Installing a water heater in your home will give you better experience of showering. It can help you relax your mind especially during cool months. So, you don’t have to fight against the breeze outside that can make your body frozen. How to install a water heater is actually easy. You can do some steps to build it to save fifty percent of the installation cost by a professional.
Before installing a water heater, you need to verify local ordinances and building codes. Determine how much space needed to accommodate installing a water heater. Typically it needs two-foot minimum clearance around the water heater and 30 inches above it. Also, determine the type and location of the current plumbing connections, and then measure between the hot and cold water pipes. Match them to your water heater to help you install it easier. When everything has been well determined, you can purchase a water heater that suits your need. How to install water heater can be started by turning off the cold water at the main shutoff voice and the circuit breaker to disconnect the fuel source. Drain the old water heater and connect a hose to the drain valve putting the open end where the water can drain. Open a hot water spigot and release drain valve slowly. Disconnect the water pipes using a pipe wrench or tongue and groove pliers and remove the gas pipe, and then detach the gas flue. Work with a helper to remove the old water heater and make sure the floor is clean and dry before moving the new water heater into the place. After that you can install the pressure relief, reconnect the water lines and seal copper connections with Teflon tape using joint compound on galvanized fittings. Fill the tank and reconnect the electrical wiring. Turn on the water heater by setting it up between 110 and 130 degrees.
This is how to install a water heater. Although it seems complicated, you can learn how to do it to install the water heater in your home our own.
Popular Post This Week